Contents
iii
Special C-bit for G28,G29 and G30 (C224~C225) 6-20
Axial Motion Command in JOG Mode (C228) 6-20
G01 Feed-rate Adjustment by MPG Hand-wheel (C229,C230) 6-21
Load File from EPROM/FLASH-Rom (C231) 6-21
Clear G54 Work Coordinates (C232) 6-21
Program Simulation Without V-command and Encoder Feedback (C235) 6-21
MPG Hand-wheel Feed Interrupt Mode (C242) 6-21
MMI (Man Machine Interface) or LCD Screen In Sleep Mode (C243) 6-22
Suppressing Alarm ERROR-2 When Following Count>4096 (C244) 6-22
Re-defined Key board Key (C245) 6-22
LCD Display Function Disabled (C247) 6-23
User Defined Keyboard Function Output (C255) 6-23
6.3 Description of PLC Register 6-23
6.4 Variables 6-33
6.5 Input and Output Signal (I-Bits & O-Bit) 6-36
7 LADDER DIAGRAM 7-1
7.1 Introduction To Ladder Diagram 7-1
7.1.1 Interface Signal Definitions For PLC Ladder Diagram 7-1
7.1.2 Maximum Input/Output Point For PLC And PLC Editor 7-1
7.1.3 PLC And PLC Editor Graphical Symbols 7-2
7.2 Composition And Modification Of A Ladder Diagram 7-2
8 LADDER EPROM INSTALLATION 8-1
8.1 EPROM Writer 8-1
8.2 Writing Ladder Program into EPROM and Flash-Rom 8-1
8.3 EPROM Installation 8-2
To Next Page
Loading...