Pg 1.1 V18 2001f
SAFETY CONSIDERATIONS
All safety precautions must be observed during installation, operation, or repair work on the V-18 II bandsaw
machine.
Inspect the machine throughly before power hook-up. Pay special attention to the electrical and hydraulic
systems to ensure no damage was caused in shipping.
Power hook-up should be performed by qualified personel.
If not performing properly the machine should be stopped immediately and set-up or repaired by a qualified
person.
Stock must not be loaded while the blade is running and the V-18 II should not be operated unless all guards,
covers and doors are in place and closed.
Long and heavy stock should be supported where it extends off the saw table.
Operator should keep a safe distance from all moving parts especially the blade and operating vises.
Long hair, loose clothing, or gloves, should not be worn while operating the V-18 II.
Area around the machine should be kept clean and tidy.
The V-18 II machine should be used according to its specifications.
The operator must wear eye protection.
No modifications to the machine are allowed without Hyd-Mech’s prior approval. Any approved
modifications shall be performed by trained personnel.
SECTION 1, INSTALLATION
To Next Page
Loading...
