Hypertherm POWERMAX 45 User Manual

Power suPPly setuP
2-2 powermax 45 Operator Manual
Operator Manual
Quick Setup Card
Registration Card
200–240V (CSA)
(plug included)
Box with extra
consumables
Setup DVD
or
Remote-start pendant (optional) Shoulder strap
Unpack the Powermax45
1. Verify that all items on your order have been received in good condition. Contact your distributor if any parts are
damaged or missing.
2. Inspect the power supply for damage that may have occurred during shipping. If there is evidence of damage,
refer to Claims, below. All communications regarding this equipment must include the model number and the serial
number located on the bottom of the power supply.
3. Before you set up and operate this Hypertherm system, read the Safety and Compliance Manual.
Claims
• Claims for damage during shipment – If your unit was damaged during shipment, youmust file a claim
with the carrier. Hypertherm will furnish you with a copy of the bill oflading upon request. If you need additional
assistance, call the nearest Hypertherm office listed in the front of this manual.
• Claims for defective or missing merchandise – If any component is missing or defective, contact your
Hypertherm distributor. If you need additional assistance, call thenearest Hypertherm office listed in the front of
this manual.
Contents
Verify the items in the box against the illustration.
230V (CE)
(plug not included)
400V (CE)
480V (CSA)
(plug not included)

Hypertherm POWERMAX 45 Specifications

General

Brand	Hypertherm
Model	POWERMAX 45
Category	Welding System
Language	English