• IBM SSIC (System Storage Interoperation Center) (http://www-03.ibm.com/systems/support/storage/
ssic/interoperability.wss).
• The latest version of the device driver or IBM Power RAID adapter utilities (iprutils) can be downloaded
from the IBM Service and Productivity Tools website (http://www14.software.ibm.com/webapp/
set2/sas/f/lopdiags/home.html).
• For support details, see the Linux Alert website (http://www14.software.ibm.com/webapp/set2/sas/f/
lopdiags/info/LinuxAlerts.html).
PCIe3 2-port 100 Gb EDR InniBand adapter (FC EC3E and EC3F; CCIN 2CEA)
Learn about the specications and operating system requirements for the feature code (FC) EC3E
adapter.
Overview
FC EC3E and EC3F are both the same adapter with different feature codes. FC EC3E is a low-prole
adapter and FC EC3F is a full-height adapter.
The PCIe3 2-port 100 Gb enhanced data rate (EDR) InniBand adapter provides high-speed connectivity
with other servers or InniBand switches. Each port maximum of 100 Gb assumes that no other system
and or switch bottlenecks are present. The adapter allows full bandwidth for a single EDR port in a PCIe3
slot and up to 128 Gb/s minus overheads for all ports. Each port maximum of 100 Gb/s assumes that no
other system and or switch bottlenecks are present.
Note: The Virtual Protocol Interconnect (VPI) feature is not supported on this adapter. The adapter must
be used only as an InniBand adapter.
94
Power Systems: Managing PCIe adapters
To Next Page
Loading...
Need help?
General
