IBM Aptiva 2134 - Diagnostics Control Keys

Diagnostics Control Keys
The following is a list of the Diagnostics Control Keys, when used and a
description of the Diagnostics response.
Control Keys When Used Diagnostics Response
Ctrl+A Main Menu Allows you to select test from the sub
menus that are highlighted with red
letters.
Attention: If selected, these test will
erase the information stored on the
diskette or hard disk drive.
Up and Down
Arrow Keys
Main Menu
Module Test
Menu
Test Group
Menu
Highlights an item you want to select.
Space Bar Module Test
Menu
Test Group
Menu
Adds a to the left of the highlighted
test. The test will run when Run All
Selected is highlighted and the Enter
key is pressed.
Also removes the to the left of the
item. The test will not run when Run
All Selected is highlighted and the
Enter key is pressed.
Tab Key Main Menu
Module Test
Menu
Selects the additional test for the
menu you are in.
+/− Keys Test Group
Menu
Selects additional test. The LUN
displayed on the top right Test Group
Menu shows which test is selected
and how and remain (example LUN 1
of 2).
3-16