(continued)
004 (continued)
– Go to “Factory-Installed Drive Devices” on page 2-46.
005
(From step 002)
DO ANY MESSAGES, ERROR CODES, OR SYMPTOMS APPEAR?
Yes No
006
– Go to Step 008.
007
– Go to “Index of Symptoms, Messages, Error Codes, or Beeps” on
page 2-9.
008
(From step 006)
– If not already inserted, place the Diagnostics and Utilities CD in the
CD-ROM drive.
– Power-off the system unit.
– Power-on the system unit, and check for the following responses:
1. One short beep
2. Readable instructions or Main Menu
DID THE SYSTEM PRODUCE THE BEEP AND READABLE SCREEN?
Yes No
009
– Go to “Index of Symptoms, Messages, Error Codes, or Beeps” on
page 2-9.
010
If the keyboard responds incorrectly, go to “Keyboard” on page 2-40.
If the monitor shows problems, such as jittering, shifting, or being out of
focus, go to “Monitor” on page 2-66 and run the Diagnostics and
Utilities tests.
If a message or error code is displayed, go to “Index of Symptoms,
Messages, Error Codes, or Beeps” on page 2-9.
(Step 010 continues)
2-6
To Next Page
Loading...
