Table 2-1 (Page 24 of 25). POST and Diagnostics and Utilities Index
for Symptoms, Messages, Error Codes, or Beeps
Symptoms, Messages, Error
Codes, or Beeps
Action/FRU
1804 - PCI Error (memory below
1 MB not available).
A PCI adapter card has requested a
memory address that is not available.
1. Choose ISA Legacy Resources from
the Setup Utility main menu, and make
sure the memory resources settings for
ISA legacy adapter cards are correct.
If the settings are not correct, change
the settings.
2. If all memory resources are being used
by ISA legacy adapter cards, you might
need to remove an ISA card to make
memory available to the PCI adapter
card.
1805 - PCI Error (ROM error). Remove the PCI adapter card.
Restart the computer without the card
installed. If the computer restarts without
an error, reinstall the card and restart the
computer again. If the error reoccurs, the
adapter card might be defective.
1962 - Boot Sequence Error. Choose Start Options from the Setup Utility
main menu, and make sure that startup
devices are set correctly. See “Assembly
9: Software” on page 7-21 to obtain
recovery diskettes, and see “Software
Installation Procedure” on page 4-42 for
installation instructions.
1996 - Boot Sequence Error. See “Hard Disk Drive Boot Error” on
page 3-14.
2401 - Monitor changing colors. Monitor
2408 error System Board
2409 error Monitor
2410 error System Board
24XX - Video/monitor error. “Monitor” on page 2-66
Optional video memory.
System Board
Monitor
Check Procedures 2-33
To Next Page
Loading...
Need help?
General