010 (continued)
Check all adapter card cables and connectors for proper installation.
Make sure all of the above are set correctly and show the correct
voltages and continuity. Replace any defective cables or adapter
cards. See “Power Supply” on page 2-35, “System Board
Layout—Type A-1” on page 5-2, and “System Board Layout—Type
A-2” on page 5-5.
– Run the Easy Test Diagnostics test again.
– If an error or other symptom is displayed, go to “Index of Symptoms,
Messages, Error Codes, or Beeps” on page 2-9.
– If no error can be detected or the symptom is intermittent, go to
“Undetermined Problem” on page 2-70.
Check Procedures 2-45
To Next Page
Loading...
