IBM Aptiva 2144 - Page 243

removing parts (continued)
machine type 54 (continued)
battery 4-21
cache, type I-1 4-14
cache, type I-2 4-16
cover 4-3
hard disk drive 4-8
LED and cable 4-22
left drive support bracket 4-4
power supply 4-11
processor, type I-1 4-19
processor, type I-2 4-20
right drive support bracket 4-5
riser card 4-12
SIMMs 4-13
system board 4-23
upgrade processor type I-1 4-19
upgrade processor type I-2 4-20
video memory modules, type
I-1 4-17
video memory modules, type
I-2 4-18
repair information 4-2
replacement parts A-1
replacements 4-2
return to control program 3-6
right drive support bracket,
removing 4-5
riser card
FRUs (machine type 2144) 7-5
FRUs (machine type 2168) 7-9
removing 4-12, 4-33
VESA local bus 4-12
voltages 2-52
run all tests 3-6
S
safety information ix
safety inspection guide 6-1
screen paging 3-7
secondary hard disk drive
connector 5-11
seek test 3-5, 3-6
serial port connectors 5-23
serial, interface 1-11
setup utility 1-16
—
1-22
SIMM configurations, type I-1 5-18
SIMM configurations, type I-2 5-20
SIMM description 1-27
SIMM identification 1-27
SIMM, removing 4-13, 4-34
SIMM—72 pin connector 5-30
software installation 4-42
software recovery packages,
descriptions 7-21
sound adapter card 1-9
sound adapter card jumper
settings 5-15
speaker connector 5-23
speakers 1-9
specifications 1-27
speed test 3-5
starting diagnostics 2-2
surface analysis 3-8
SVGA multi-scanning 1-10
SVGA tri-synch 1-10
switch connector 5-23
symptoms, messages, error codes, or
beeps index 2-10
sync test 3-7
system board (type I-1) layout 5-2
system board (type I-2) layout 5-5
system board bus speed settings—type
I-2 5-7
system board layouts
system board layouts, type I-2
system board, removing 4-23, 4-40
T
test
character 3-7
diskette change 3-5
display (monitor) self 3-12
error detection and correction 3-6
extended mode 3-7
graphics 3-7
monitor 3-7
Index
X-5