– Two 40-pin IDE drive controllers: a primary local bus IDE that
supports two hard disk drives and a secondary IDE that supports a
CD-ROM drive and one hard disk drive, or two hard disk drives.
– Power light-emitting diode (LED)/hard disk LED (4-pin)
Power-on switch 2-wire connector and a power supply auxiliary control
3-wire connector for Rapid Resume features.
Wake Up on Ring connector for Rapid Resume automatic wake-up
features.
Lithium battery.
Processors
One of the following processors can be installed:
AMD 486DX4-100MHz
Cyrix/IMD 486DX4-100MHz
Cyrix 5x86C-100MHz
Pentium P24T
Pentium P24CT
Pentium P54C-75MHz
Pentium P54C-100MHz
Pentium P54C-120MHz
Pentium P54C-133MHz
Pentium P54C-150MHz
Pentium P54C-166MHz
Modem Adapter Card
The following Data/FAX/Voice/Speech modem support is available:
14400 bps data / 14400 bps send and receive data/FAX/Voice
28800 bps data / 14400 bps send and receive data/FAX/Voice
The Machine Type 2144 and Machine Type 2168 are shipped with
one of the above modems installed in most U.S. and Canadian
models. Features include pulse and touchtone dial, autodial,
autoanswer, built-in speaker, and two phone jacks. Voice modem
software (for answering machine features) is also supported.
DIP switches and any external serial ports supported are preset at
the factory. Port addresses can be changed by resetting the DIP
switches or jumpers on the modem adapter card.
Refer to “Factory-Installed Modem Jumper and Switch Settings” on
page 5-10 for switch settings and jumper positions.
1-8
To Next Page
Loading...
Need help?
General