006 (continued)
DOES THE INSTALLED DEVICES LIST CORRECTLY IDENTIFY THE
DEVICES INSTALLED IN THE SYSTEM UNIT?
Note: If necessary, remove the cover and visually compare the devices
installed in the system unit to those shown in the installed devices
list.
Yes No
007
– Press N, then press Enter.
Note: A 199 error at this point indicates you answered No to the
question above in Step 006 on page 2-34. Disregard the error.
– Select 0 to add items. Press Enter.
– Select the number of the item you want to add and then press
Enter.
– Press Y, then press Enter.
– Select the 0 (RUN TESTS ONE TIME) option, then press Enter.
– Select only the item that you added to test, then press Enter.
Note: The Installed Devices list shows only those devices
supported by this manual. If a device is missing from the list
and is not factory installed, refer to the service manual
provided for that device.
If a factory-installed drive device or adapter card is not listed
in the Installed Devices list, go to either “Diagnostics for
Factory-Installed Drive Devices Not Supported by Advanced
Diagnostics” on page 2-40 or “Diagnostics for
Factory-Installed Riser Card, Sound Card, or Adapter Cards
Not Supported by Advanced Diagnostics” on page 2-43.
WERE YOU ABLE TO CORRECT THE INSTALLED DEVICES LIST
TO MATCH THE DEVICES INSTALLED IN THE SYSTEM UNIT,
WITHOUT RECEIVING AN ERROR CODE OR MESSAGE?
Yes No
008
– If you receive any messages, error codes, or beeps while
running a diagnostic test, go to “Index of Symptoms,
Messages, Error Codes, or Beeps” on page 2-10.
– If you are told to replace a failing device, do so only after
ensuring all switches, power connectors, cables, and jumpers
are set correctly and show the correct voltages. See “Power
Check Procedures 2-35
To Next Page
Loading...
