(continued)
(From step 012)
– Power off the system unit.
– Check one adapter card at a time. To do this, install the failing adapter
card in the riser card and power on the system unit.
– Repeat this with each adapter card if necessary.
IS A WINDOWS DRIVER ERROR DISPLAYED FOR THE INSTALLED
ADAPTER CARD?
Yes No
015
Go to Step 017.
016
– Check for proper installation of the adapter card.
– Check all adapter card jumper positions. See “Power Supply” on
page 2-26 and “System Board Layout—Type I-1” on page 5-2 and
“System Board Layout—Type I-2” on page 5-5.
– Check all cables and connectors on the adapter card for proper
installation.
– Check continuity of any cable attached to the adapter card and replace if
necessary.
– If the problem remains, replace the factory-installed adapter card.
– If the problem remains with a card that was not factory installed, consult
the service information provided by the card manufacturer.
017
(From step 015)
– Power off the system unit.
– Reinstall the sound adapter card or adapter card and any cables.
– Power on the system unit without the Advanced Diagnostics diskette
inserted.
Note: This procedure can be used for most factory-installed adapter
cards. However, you must select the correct window (see steps 3
and 4 below) to access the feature icon before any test or before
testing any feature in step 6.
– Perform the following when the system is running:
1. Open Microsoft Windows if not already opened by the system.
2. Select the Program Manager icon if not already opened.
3. Select Main Menu.
(Step 017 continues)
2-46