__ 43. On the Display disk configuration display, select Display disk configuration
status.
__ 44. Determine the auxiliary storage pool (ASP) to add the disk unit to.
__ 45. Press F12, twice.
__ 46. On the Work with disk configuration display, select Work with ASP
configuration.
Press the Enter key.
__ 47. On the Work with disk configuration display, select Add units to ASPS and
balance data.
Press the Enter key.
__ 48. On the Specify to Add Units to display, specify the ASP.
Press the Enter key.
__ 49. Press Enter to confirm.
__ 50. When the message “Selected units have been added successfully”, return to
the AS/400 Main menu.
__ 51. Go to step 55.
__ 52. On the Work with disk configuration display, select Add units to ASPs.
Press the Enter key.
__ 53. Add the number of the ASP you want to add the disk unit to. The system
ASP is ASP 1.
Press the Enter key.
__ 54. The Confirm Add Units display appears showing the configuration your
system will have when the add completes.
Note: If you have selected the wrong ASP, press F12 to change your
options.
Press the Enter key to continue. The add process will take several minutes
to complete.
__ 55. Install the disk unit shield cover.
__ 56. Install the system unit front cover.
__ 57. Press F12 three times to return to the Use Dedicated Service Tools (DST)
display.
__ 58. Select Perform an IPL option.
Press the Enter key.
__ 59. If you have a printer, print the configuration list. A service representative
may refer to the configuration list in the future.
a. On the AS/400 Main menu command line type:
Note: You need to be signed on with service authority.
STRSST
Press the Enter key.
b. On the STRSST display, select Start a service tool option.
Press the Enter key.
c. On the Start a Service Tool display, select Hardware service manager
option.
Press the Enter key.
d. From the Hardware Service Manager display, press F6 (print the
configuration).
Appendix C. Installing disk units in the 5065 or 5066 Expansion Unit 53
To Next Page
Loading...
Need help?
General