Reserved 0000H69-74
Minimum PIO Transfer Cycle Time Without Flow Control
15–0(=78)Cycle time in nanoseconds (120 ns, 16.6 MB/s)
0078H68
Minimum PIO Transfer Cycle Time Without Flow Control
15–0(=F0)Cycle time in nanoseconds (240 ns,8.3 MB/s)
00F0H67
Manufacturer’s Recommended Multiword DMA Transfer
Cycle Time
15-0(=78)Cycle time in nanoseconds (120 ns, 16.6 MB/s)
0078H66
Minimum Multiword DMA Transfer Cycle Time Per Word
15-0 (=78)Cycle time in nanoseconds (120 ns, 16.6MB/s)
0078H65
Flow Control PIO Transfer Modes Supported
15-8 (=0) Reserved
7-0 (=3) Advanced PIO Transfer Modes Supported
‘11’ = PIO Mode 3 and 4 Supported
0003H64
Multiword DMA Transfer Capability
15-8 Multiword DMA transfer mode active
7-0 (=7) Multiword DMA transfer modes supported
(support mode 0, 1, and 2)
xx07H63
0000H62
Total Number of User Addressable Sectors
Word 60 specifies the low word of the number
xxxxH60-61
Current Multiple setting. Bit assignments:
15–9 (=0) Reserved
8 1= Multiple Sector Setting is Valid
7–0 xxh = Current setting for number of sectors
0xxxH59
Current capacity in sectors
Word 57 specifies the low word of the capacity
xxxxH57-58
Number of current sectors per trackxxxxH56
Number of current headsxxxxH55
Number of current cylindersxxxxH54
Validity flag of the word
15–3(=0) Reserved
2(=1) 1=Word 88 are Valid
1(=1) 1=Word 64-70 are Valid
0(=1) 1=Word 54=58 are Valid
0007H53
DMA data transfer cycle timing mode
Refer Word 62 and 63
y
0200H52
PIO data transfer cycle timing mode0200H51
Capabilities, bit assignments:
15-14(=01) Word 50 is valid
13– 1(=0) Reserved
0 Minimum value of Standby timer
(=0) less than 5 minutes
(=1) equal to or greater than 5 minutes
400xH50
DescriptionContentWord
Figure 84. Identify Device Information (2 of 6)
Deskstar 60 GXP Hard disk drive specification
113
To Next Page
Loading...
