There are four jumper settings as shown in the following sections:
y
Normal use
y
15 heads
y
2 GB clip
y
Auto spin disable
Each category is exclusive. The pin assignment of the 9-pin jumper used to select "Device 0", "Device 1",
"Cable Selection", and "Device 0 with Device 1 Present" is shown in the following illustration.
The "Device 0" setting automatically recognizes Device 1 if present.
The "Device 0 with Device 1 present" setting is for a slave device that does not comply with the ATA
specification.
GND
DS
IGECA
H
D
BF
RSV
GND GND RSV
CS/SP
GND
RS V
Notes: In conventional terminology, 'Device0' means 'Master' and 'Device1' means 'Slave'.
Figure 38. Jumper pin assignment
Deskstar 60 GXP Hard disk drive specification
42
To Next Page
Loading...
