Mode definition:
Idle mode
The drive is powered on, disks spinning, track following, and unit ready to receive and respond to
interface commands.
Operating mode
Continuous random cylinder selection and seek operation of the actuator with a dwell time at each
cylinder. The seek rate for the drive is to be calculated as follows:
Dwell time = 0.5 x 60/RPM
Seek rate = 0.4/(Average seek time + Dwell time)
9.8 Identification—labels
The following labels are affixed to every drive shipped from the drive manufacturing location in
accordance with the appropriate hard disk drive assembly drawing.
• A label containing the IBM logo, the IBM part number, and the statement “Made by IBM Japan Ltd.”,
or IBM equivalent.
• A label containing the drive model number, the manufacturing date code, the formatted capacity, the
place of manufacture, and the UL/CSA/TUV/CE mark logos.
• A bar code label containing the drive serial number.
• A label containing the jumper pin description.
• A user designed label per agreement.
The above labels may be integrated with other labels.
9.9 Safety
9.9.1 UL and CSA standard conformity
The product is qualified per UL 1950 Third Edition and CAN/CSA C22.2 No. 950-M95, Third Edition, for
use in Information Technology Equipment including Electric Business Equipment.
The UL recognition or the CSA certification is maintained for the product life.
The UL and C-UL recognition mark or the CSA monogram for CSA certification appear on the drive.
9.9.2 IEC compliance
The product is certified for compliance to IEC 950. The product complies with these IEC requirements for
the life of the product.
9.9.3 German Safety Mark
The product is approved by TUV on Test requirement—EN 60 950:1992/A1-4—but the GS mark is not
applicable to internal devices such as this product.
Deskstar 60 GXP Hard disk drive specification
57
To Next Page
Loading...
