15.32.12.7 S.M.A.R.T. capability
This word of bit flags describes the S.M.A.R.T. capabilities of the device. The device will return 03h
indicating that the device will save its Attribute Values prior to going into a power saving mode and
supports the S.M.A.R.T. ENABLE/DISABLE ATTRIBUTE AUTOSAVE command.
Reserved (0)
2–15
If bit = 1, the device supports the S.M.A.R.T. ENABLE/DISABLE ATTRIBUTE
AUTOSAVE command.
Attribute auto save capability
1
If bit = 1, the device will save its Attribute Values prior to going into a power saving mode
(Standby or Sleep mode).
Pre-power mode attribute saving capability
0
DefinitionBit
15.32.12.8 Error logging capability
Error Logging support bit
0
Reserved (0)
7–1
DefinitionBit
If bit = 1, the device supports the Error Logging
15.32.12.9 Self-test failure check point
This byte indicates the section of the self-test where the device detected a failure.
15.32.12.10 Self-test completion time
These bytes are the minimum time in minutes to complete the self-test.
15.32.12.11 Data Structure Checksum
The Data Structure Checksum is the two's compliment of the result of a simple 8-bit addition of the first
511 bytes in the data structure.
Deskstar 60 GXP Hard disk drive specification
168
To Next Page
Loading...
