Input parameters from the device on bus release
Sector Count
Bits 7–3 (Tag) contain the Tag of the command being bus released.
Bit 2 (REL) is set to one.
Bit 1 (I/O) is cleared to zero.
Bit 0 (C/D) is cleared to zero.
Sector Number, Cylinder High/low, H
n/a.
SRV
This parameter is cleared to zero when the device performs a bus release. This
bit is set to one when the device is ready to transfer data.
Input parameters from the device on command complete
Sector Count
Bits 7–3 (Tag) contain the Tag of the completed command.
Bit 2 (REL) is cleared to zero.
Bit 1 (I/O) is set to one.
Bit 0 (C/D) is set to one.
Sector Number, Cylinder High/Low, H
The sector address of unrecoverable error—applicable only when an
unrecoverable error has occurred.
SRV
This parameter is cleared to zero.
Deskstar 60 GXP Hard disk drive specification
127
To Next Page
Loading...
