Step 1522-14
Reinsert the following components in the CEC drawer, one at a time, disconnecting the ac power cable (dc
power cable in a dc-powered system) to each power supply before reinsertion and reconnecting the ac
power cable (dc power cable for a dc-powered system) to each power supply after reinsertion:
1. CEC processor card(s)
2. CEC RIO adapter card
3. CEC memory card(s)
Does
the CEC power on?
NO Replace the defective card just reinserted.
Reinsert any remaining cards in this step.
This ends the procedure. Go to ″MAP 0410: Repair Checkout″ in the RS/6000 and Eserver
pSeries Diagnostic Information for Multiple Bus Systems.
YES Go to “Step 1522-15.”
Step 1522-15
Have all cards in this step been reinserted?
NO Go to “Step 1522-14.”
YES The symptom has changed. Call your next level of support for assistance.
This ends the procedure.
Step 1522-16
Replace the following in the CEC drawer, one at a time, disconnecting the ac power cable (dc power cable
in a dc-powered system) to each power supply before replacement and reconnecting the ac power cable
(dc power cable for a dc-powered system) to each power supply after replacement:
1. CEC regulator card
2. CEC backplane
Does
the CEC power on?
NO Go to “Step 1522-17” on page 97.
YES Reinsert the cards removed in “Step 1522-13” on page 95.
This ends the procedure. Go to ″MAP 0410: Repair Checkout″ in the RS/6000 and Eserver
pSeries Diagnostic Information for Multiple Bus Systems.
96 Service Guide
To Next Page
Loading...
Need help?
General