Step 1524-7
1. Turn off the power.
2. Disconnect the ac power cables (dc power cables in a dc-powered system) from the CEC drawer.
3. Reinstall one of the cards that was removed in “Step 1524-1” on page 106, in the sequence listed:
a. CEC regulator at M01
b. CEC RIO adapter at M06
c. CEC memory riser 1 at M02
d. CEC memory riser 2 at M05 (if present)
e. CEC processor at M03
f. CEC processor at M04 (if present)
4. Reconnect the ac power cables (dc power cables in a dc-powered system) to the CEC drawer.
5. Turn on the power.
Is the error code 1011 1C0x displayed?
NO Go to “Step 1524-8.”
YES The last card you installed is defective. Replace the last card you installed.This ends the
procedure. Go to ″MAP 0410: Repair Checkout″ in the RS/6000 and Eserver pSeries Diagnostic
Information for Multiple Bus Systems.
Step 1524-8
Have all the cards that were removed in “Step 1524-7” been reinstalled?
NO Go to “Step 1524-7” and reinstall the next card in the list.
YES Replace the CEC backplane, location: U1.1-P1.
This ends the procedure. Go to ″MAP 0410: Repair Checkout″ in the RS/6000 and Eserver
pSeries Diagnostic Information for Multiple Bus Systems.
Chapter 3. Maintenance Analysis Procedures 109
To Next Page
Loading...
Need help?
General