Step 1524-5
1. Turn off the power.
2. Reinstall CEC power supply 2 that was removed in “Step 1524-4” on page 107.
3. Reconnect the ac power cable (dc power cable in a dc-powered system) to the CEC power supply 2.
4. Remove CEC fan 1. Disregard a CEC fan error code if it occurs during this step.
5. Turn on the power.
Is the error code 1011 1C0x displayed?
NO Replace CEC fan 1, location: U1.1-F1.This ends the procedure. Go to ″MAP 0410: Repair
Checkout″ in the RS/6000 and Eserver pSeries Diagnostic Information for Multiple Bus Systems.
YES Go to “Step 1524-6.”
Step 1524-6
1. Turn off the power.
2. Reinstall CEC fan 1 that was removed in “Step 1524-5.”
3. Remove CEC fan 2. Disregard a CEC fan error code if it occurs during this step.
4. Turn on the power.
Is the error code 1011 1C0x displayed?
NO Replace CEC fan 2, location: U1.1-F2.This ends the procedure. Go to ″MAP 0410: Repair
Checkout″ in the RS/6000 and Eserver pSeries Diagnostic Information for Multiple Bus Systems.
YES Replace the CEC backplane, location: U1.1-P1.This ends the procedure. Go to ″MAP 0410:
Repair Checkout″ in the RS/6000 and Eserver pSeries Diagnostic Information for Multiple Bus
Systems.
108 Service Guide
To Next Page
Loading...
Need help?
General