Table 2. Firmware Checkpoints (continued)
Checkpoint Description Action/
Possible Failing FRU
E604 SSA PCI adapter BIST and
subsequent POSTs have
completed successfully.
Replace the adapter. See
“Determining Location Code”
on page 160 for location
code information related to
this error.
E605 SSA PCI adapter BIST has
completed successfully but the
subsequent POSTs have failed.
Replace the adapter. See
“Determining Location Code”
on page 160 for location
code information related to
this error.
E60E SSA PCI adapter open firmware
about to exit (no stack
corruption).
Replace the adapter. See
“Determining Location Code”
on page 160 for location
code information related to
this error.
E60F SSA PCI adapter open firmware
has run unsuccessfully.
Replace the adapter. See
“Determining Location Code”
on page 160 for location
code information related to
this error.
E6FF SSA PCI adapter open firmware
about to exit (with stack
corruption).
Replace the adapter. See
“Determining Location Code”
on page 160 for location
code information related to
this error.
E700 Create system firmware VPD Replace the primary I/O
drawer backplane.
E701 Create memory VPD. See “Note” on page 137.
E702 Create processor card VPD. See “Note” on page 137.
E703 Create operator panel VPD. See “Note” on page 137.
E704 Create CEC VPD. See “Note” on page 137.
E705 Create clock card VPD. See “Note” on page 137.
E706 Create RIO extender card VPD. See “Note” on page 137.
E707 Create system VPD. See “Note” on page 137.
E708 Create RIO to PCI adapter
VPD.
See “Note” on page 137.
E709 Create VPD via SPCN. See “Note” on page 137.
E70A Create service processor VPD. See “Note” on page 137.
E8xx RTAS initialization problem. Call for support.
EAA1 Probe PCI-PCI bridge. Follow the repair actions for
checkpoint E151.
Note: If you receive a four-digit code in the range of E1xx to EFFF that is not listed in the table above, go
to “MAP 1540: Minimum Configuration” on page 110.
154 Service Guide
To Next Page
Loading...
Need help?
General