If the ring-indicate power-on setting is changed, you must select option 30 (Refresh Modem Settings) to
update the modem settings. If option 30 (Refresh Modem Setting) is selected, and the modem(s) have
not been configured, you will be asked to configure the modems first. See “Call-In/Call-Out Setup Menu”
on page 380 for information on configuring modems.
Option 2 is used to set the number of rings.
Note:
In order for the ring-indicate power-on settings to take effect and ring-indicate power-on to be
enabled, the service processor menus must be exited completely. Enter 99 at the Main Menu
screen to completely exit the service processor menus.
v Reboot/Restart Policy Setup Menu
The following menu controls reboot/restart policy:
Reboot/Restart Policy Setup Menu
1. Number of reboot attempts:
Currently 1
2. Use OS-Defined restart policy?
Currently Yes
3. Enable supplemental restart policy?
Currently No
4. Call-Out before restart:
Currently Disabled
98. Return to Previous Menu
1>
Reboot is the process of bringing up the system hardware; for example, from a system reset or power
on. Restart is activating the operating system after the system hardware is re-initialized. Restart must
follow a successful reboot.
– Number of reboot attempts - If the server fails to successfully complete the boot process, it
attempts to reboot the number of times specified. Values equal to or greater than 0 are valid. Only
successive failed reboot/restart attempts are counted.
– Use OS-Defined restart policy - Allows the service processor to react or not react in the same way
as the operating system to major system faults by reading the setting of the operating system
parameter Automatically Restart/Reboot After a System Crash. This parameter may or may not
be defined, depending on the operating system or its version/level. If the operating system automatic
restart setting is defined, then it can be set to respond to a major fault by restarting or by not
restarting. See your operating system documentation for details on setting up operating system
automatic restarts. The default value is Yes.
Chapter 8. Using the Service Processor 369
To Next Page
Loading...
