pscp -i ssh_private_key_file
superuser@cluster_ip:/tmp/svc.config.restore.prepare.log
full_path_for_where_to_copy_log_files
14. Open the log file from the server where the copy is now stored.
15. Check the log file for errors.
v If there are errors, correct the condition that caused the errors and reissue
the command. You must correct all errors before you can proceed to step 16.
v If you need assistance, contact the IBM Support Center.
16. Issue the following CLI command to restore the configuration:
svcconfig restore -execute
This CLI command creates a log file in the /tmp directory of the configuration
node. The name of the log file is svc.config.restore.execute.log.
17. Issue the following command to copy the log file to another server that is
accessible to the system:
pscp -i ssh_private_key_file
superuser@cluster_ip:/tmp/svc.config.restore.execute.log
full_path_for_where_to_copy_log_files
18. Open the log file from the server where the copy is now stored.
19. Check the log file to ensure that no errors or warnings have occurred.
Note: You might receive a warning stating that a licensed feature is not
enabled. This message means that after the recovery process, the current
license settings do not match the previous license settings. The recovery
process continues normally and you can enter the correct license settings in
the management GUI at a later time.
When you log into the CLI again over SSH, you see this output:
IBM_2076:your_cluster_name:superuser>
20. After the configuration is restored, perform the following actions:
a. Verify that the quorum disks are restored to the MDisks that you want by
using the lsquorum command. To restore the quorum disks to the correct
MDisks, issue the appropriate chquorum CLI commands.
b. Reset the superuser password. The superuser password is not restored as
part of the process.
c. If the output from the svcconfig CLI command indicated that the layer
could not be restored, change the layer to the correct setting using the
chsystem CLI command.
You can remove any unwanted configuration backup and restore files from the
/tmp directory on your configuration by issuing the following CLI command:
svcconfig clear -all
Deleting backup configuration files using the CLI
You can use the command-line interface (CLI) to delete backup configuration files.
Perform the following steps to delete backup configuration files:
1. Issue the following command to log on to the system:
plink -i ssh_private_key_file superuser@cluster_ip
Chapter 7. Recovery procedures 77
|
|
|
To Next Page
Loading...
Need help?
General