IBM SUREMARK TF6

Code page 865
Character fonts
This section describes font capabilities. For more information about font-related
commands, see:
v “Download user-defined characters” on page 118
v “Set print station” on page 134
v “Set print mode” on page 129
v “Set code page” on page 135
v “Set intercharacter spacing” on page 135
v “Select user-defined or resident character sets” on page 134
Thermal printing font
There are three font sizes for the resident character set on Models TI3, TI4, TI8,
TI9, TG3, TG4, TG8, TG9, TF6, and TM6 (only fonts A and B are available for
Models TI1 and TI2):
v Font A is 10 dots (wide) × 20 dots (high) with the last 2-dot row used for
descenders.
(1.25 mm × 2.5 mm character height including descenders, 1.25 mm × 2.25 mm
excluding descenders)
v Font B is 12 dots (wide) × 24 dots (high) with the last 2-dot row used for
descenders.
(1.5 mm × 3.0 mm character height including descenders, 1.5 mm × 2.75 mm
excluding descenders)
Figure 49. Code Page 865
Updated April 2, 2009
98 SureMark Printers User’s Guide