Example: 10 wide × 20 high
Defined as:
X'1B26014848 C0C0C0C0C0C0C0C0C0C0C0C0C0C0FFC0FFC0F
C0C0C0C0C0C0C0C0C0C0C0C0C0C0C0C0C0C0'
The above statement defines character X'48' as an ’H’.
Note: The number of data bytes=2×dotheight (20) = 40 bytes.
Proportional font
This command is supported only for Models TI3, TI4, TI8, TI9, TG3, TG4, TG8,
TG9, TF6 and TM6.
EIA-232 Syntax:
ESC & s n m data or X'1B;26;s;n;m;data'
where:
s The character set being defined.
1 User-defined thermal code page 1.
3 User-defined thermal code page 3.
n The beginning ASCII address of the characters being defined.
m The ending ASCII address of the characters being defined.
data The height and width of the character, and the matrix pattern for the
data. The number of data bytes is (m−n+1) × (2+wb×32). wb is
defined in the MCT command.
Purpose:
To download and print proportional fonts (True Type fonts) in the thermal
station. Each character in the code page has its own unique width and
height. The matrix must be within the following ranges:
Updated April 2, 2009
120 SureMark Printers User’s Guide
To Next Page
Loading...
Need help?
General
