11. For thermal/impact SureMark printers, locate the ribbon cartridge and install it
in the printer. (See “Ribbon loading” on page 51.) Be sure that the ribbon is
routed through the print head correctly.
12. Load the paper roll into the printer. See “Paper loading” on page 53 for
thermal/impact SureMark printers or “Paper loading” on page 71 for
single-station SureMark printers.
13. Installation is now complete. Go to Chapter 5, “Testing and problem analysis,”
on page 61 for thermal/impact printers or Chapter 7, “Testing and problem
analysis (Models TF6 and TM6),” on page 75 for single-station printers and run
the offline tests.
Installing SureMark for USB communication
1. Disconnect the power brick from the printer, if one is connected.
2. Locate the rear cable connectors on the printer.
Cash
Drawer
Port
Power
Supply
Port
Powered
USB Port
Standard
USB Port
Figure 9. USB Ports for thermal/impact SureMark printers. (View is from the bottom rear of
the printer)
Updated April 2, 2009
Chapter 2. Installation instructions 21
To Next Page
Loading...
Need help?
General
