4. Reach inside the document insert station and carefully remove the jammed
check.
5. Reinstall the check flipper cartridge and the lower DI cover.
MICR reader read head cleaning
The MICR reader read head should be cleaned after 10000 checks are processed
or every 3 months, as required.
1. Open the ribbon cover.
2. Move the impact printhead to its rightmost position.
3. Rotate the document sensor assembly towards the front of the printer to expose
the MICR read head.
4. Use a cotton swab that is lightly soaked with alcohol to wipe any residue or dirt
from the MICR read head surface.
5. Gently return the document sensor assembly to its original position.
Figure 31. Removing the check flipper cartridge (except Models TI8, TI9)
Updated April 2, 2009
56 SureMark Printers User’s Guide
%
%
%
%
%
%
%
%
%
%
%
To Next Page
Loading...
Need help?
General
