Setting Default Value
Print Mode 00
Print Station Selected 02
User-Defined/Resident Character Sets 00
Code Page 01
Intercharacter Spacing (Single Byte) 03
Rotated Characters 00
Station for line spacing 02
Line Spacing all stations Six LPI
Tab Positions every 100 dots
Left Margin 00
Relative Position 00
Align Positions 00
Unidirectional printing 00
Horizontal Size of Bar Code 03
Vertical Size of Bar Code A2
Position of HR 00
Font for HRI 00
Error Conditions:
None
Enable or disable the feed buttons
EIA-232 Syntax:
ESCc5n or X'1B;63;35;n'
where:
n=0 Enables feed buttons
n=1 Disables feed buttons
Default:
n=0
Purpose:
To disable the feed buttons while in the middle of a transaction.
Remarks:
If the printer is set to have the buttons disabled, the offline tests will also be
disabled. Supported on all models except TI1 and TI2.
Enable or disable the beeper (Models TF6 and TM6 only)
This command is supported only for Models TF6 and TM6.
EIA-232 Syntax:
ESC BEL n1 n2 or X'1B 07 n1 n2'
where:
n1 Enables or disables beeper.
X'00' Disable beeper.
X'01'–X'FE'
Timed enable beeper.
X'FF' Enable beeper.
n2 Sets the beeper volume and tone.
Updated April 2, 2009
Appendix D. EIA-232 programming information 143
To Next Page
Loading...
Need help?
General
