Fix font matrix
This command is not supported for Models TI1 and TI2.
EIA-232 Syntax:
ESC : n or X'1B 3A n'
where:
n The character width to which all proportional characters will be
adjusted. The range of valid values is 8 ≤ n ≤ 32. Use X'00' to
disable this command and print proportional characters normally.
Default:
n=00
Purpose:
To fix the matrix of proportional fonts. This command will be used mostly to
align numbers and decimal points.
Remarks:
v This command is valid only on proportional user-defined fonts.
v If the character is larger than the width defined by this command, then
the right side of the character will be truncated.
v If the character is smaller than the width defined by this command, then
the character will be centered in the space.
Print logo inline
This command is not supported for Models TI1 and TI2.
EIA-232 Syntax:
GS J d n1 n2 data or X'1D 4A d n1 n2 data'
where:
d Relative height of the character.
0 Single high
1 Double high
n1 MSB of the logo width.
n2 LSB of the logo width.
data The data to form the graphics image.
Purpose:
To print a small logo inline with characters.
Remarks:
v Thermal station only
v Rotate characters must be disabled
v n1 and n2 indicate the number of dots of the bit image in the horizontal
direction. The number of dots is calculated as n1×256+n2 (after first
converting n1 and n2 to decimal).
v The logo is 24 dot rows high. If printed in double-high mode, the logo will
be 48 rows high.
v The number of data bytes to form the image is figured by
{((n1×256+n2)−1)/8+1}×24.
Updated April 2, 2009
146 SureMark Printers User’s Guide
To Next Page
Loading...
Need help?
General
