IBM SUREMARK TF6

4. If you have a short keyboard, place the keyboard filler beside the keyboard. See
Figure 13 on page 25.
5. Place the printer filler beside the display filler. Make sure you route the printer
cable to the side, as shown in Figure 13 on page 25.
Installing fillers for USB printers
1. Disconnect the power brick from the printer (if connected).
2. Place the display filler appropriate for the video display on the system unit. See
Figure 14 on page 27.
3. If you have a short keyboard, place the keyboard filler beside the keyboard. See
Figure 14 on page 27.
4. Place the printer filler beside the display filler. Make sure you route the
keyboard cable to the side, as shown in Figure 14 on page 27.
Updated April 2, 2009
26 SureMark Printers User’s Guide