Scanned check printout (ModelsTI8, TI9, TG8, TG9)
Following the description of the test, Models TI8, TI9, TG8, and TG9 also print a
copy of the check that has been scanned. This printout is in black and white, not
grayscale.
EIA-232 hex dump
To enable hex dump mode for the printer:
Power off the printer, press and hold the paper feed button and then power on the
printer with the paper feed button still pressed.
To exit, power OFF or reset the printer.
Resetting the printer - offline
1. Press and hold both buttons (Customer Receipt Feed button and Document
Feed button) to enter offline mode.
2. Release both buttons when the Printer Ready indicator begins to blink.
3. Open the customer receipt cover, then close it. The printer resets.
Electronic journal dump
Note: Electronic journal data must be formatted and stored as printed lines for the
journal data to be printed in readable format.
1. Press and hold both buttons (Customer Receipt Feed button and Document
Feed button) to enter offline mode.
2. Release both buttons when the Printer Ready indicator begins to blink.
3. Press and release both buttons.
Figure 39. MICR reader test results: Noise level needs adjusting
Updated April 2, 2009
66 SureMark Printers User’s Guide
To Next Page
Loading...
Need help?
General
