Byte 3
First byte of features
Bit 0
v When byte 1 = X'30': Set to 1 when MICR is present
v When byte 1 = X'31': Reserved
Bit 1
v When byte 1 = X'30': Set to 1 when Check Flipper is
present
v When byte 1 = X'31': Reserved
Bit 2
v When byte 1 = X'30': Set to 1 when the printer has the 2
MB option
v When byte 1 = X'31': Reserved
Bit 3 Set to 1 when the printer is in XON/XOFF mode
Bit 4 Reserved
Bit 5
v When byte 1 = X'30': Set to 1 when the 2 MB option is
used for user flash memory
v When byte 1 = X'31': Reserved
Bit 6 Set to 1 when two-color printing is enabled.
Bit 7 Set to 1 when the printer is in Model 4 emulation mode.
Byte 4
Second byte of features
Bit 0 Set to 1 when printer is set for 58 mm paper
Bit 1 Set to 1 if Model TI8/TG8 or TI9/TG9 is in TI4 mode when
byte 1 is set to X'30'
Bit 2 Set to 1 if full scanning Model TI9 or TG9 printer
Bit 3 Set to 1 when the USB interface is internal to the printer
Bits 4
Set to 1 when the printer is an RPQ, which disables the
scanner
Bits 5–7
Reserved
Byte 5
EC level = EC level of loaded code
Error Conditions:
None.
Remarks:
This is an IMMEDIATE command.
Updated April 2, 2009
Appendix D. EIA-232 programming information 113
To Next Page
Loading...
Need help?
General
