Table 24. Retrievable usage data (continued)
Hex Value Usage Data Being Tracked Factor
86 Number of failed paper cuts - single-station printers only None
87 Number of characters printed at the DI (impact) station -
thermal/impact printers only (see Note 1)
1 000
88 Number of steps performed by the DI paper feed motor 50 000
89 Number of DI transport motor starts 5 000
8A Number of home errors - thermal/impact printers only (see
Note 2)
None
8B Number of times the DI cover was opened - thermal/impact
printers only (see Note 2)
None
8C Number of forms that were inserted into the DI station -
thermal/impact printers only
100
8D Number of MICR reads - Tx4, Tx8, Tx9 16
8E Number of high-interference MICR reads 8
8F Number of failed MICR reads 8
90 Number of check flips performed 16
91 Number of check flip failures 8
92 Remainder value of CR motor steps (from 0x84) (see Note
2)
None
93 Remainder values of paper cuts (from #0x84) (see Note 1
and 2)
None
94 Remainder values of DI characters printed (from #0x87) (see
Note 1 and 2)
None
95 Remainder values of DI paper feed motor steps (from #0x88)
(see Note 2)
None
96 Remainder values of forms inserted into DI station (from
#0x8C) (see Note 2)
None
97 Remainder values of DI transport motor starts (from #0x89)
(see Note 2)
None
98 Remainder values of check flip failures - Tx4, Tx8, Tx9 (from
#0x91) (see Note 2)
None
99 Remainder values of failed MICR reads - Tx4, Tx8, Tx9
(from #0x8F) (see Note 2)
None
9A Remainder values of check flips performed - Tx4, Tx8, Tx9
(from #0x90) (see Note 2)
None
9B Remainder values of MICR reads - Tx4, Tx8, Tx9 (from
#0x8D) (see Note 2)
None
9C Remainder values of high interference MICR reads - Tx4,
Tx8, Tx9 (from #0x8E) (see Note 2)
None
9D Remainder values of bar codes printed (from #0xD8) (see
Note 2)
None
9E Remainder values of scanned documents - Tx8, Tx9 only
(from #0xD3) (see Note 2)
None
9F Remainder values of cash drawer successful (from #0xD6)
(see Note 2)
None
D2 Number of flash erase commands performed (NVRAM write
count) (see Note 2)
None
Updated April 2, 2009
Appendix D. EIA-232 programming information 163
To Next Page
Loading...
Need help?
General
