IBM ThinkPad 600 User Manual

Problem Action
The computer does not
return from suspend
mode, or the suspend
indicator stays on and the
computer does not work.
The computer automatically enters suspend or hibernation mode when the
battery power is exhausted. Do one of the following:
Replace the battery pack with a fully charged one and then press Fn.
Connect the AC Adapter to the computer; then press Fn.
The LCD is blank after
resuming.
Check if an external monitor was connected before the computer entered
suspend mode. Do not disconnect the external monitor while the computer
is in suspend mode or hibernation mode. If no external monitor is
attached when the computer resumes, the LCD remains blank and output
is not displayed. This restriction does not depend on the resolution value.
Your computer does not
enter suspend or
hibernation mode.
Check if the suspend or hibernation mode is disabled.
If you are using the AC Adapter and your computer is connected to a network,
do the following:
For Windows 95:
1. Start the ThinkPad Configuration program.
2. Click on Power Management (
).
3. Click on the Hibernation tab.
4. Make sure that hibernation mode is enabled.
For Windows NT:
1. Start the ThinkPad Configuration program.
2. Click on Power Management (
).
3. Click on Suspend/Resume Options ( ).
4. Make sure that hibernation mode is enabled.
5. Click on OK.
110 IBM ThinkPad 600 Online Book

IBM ThinkPad 600 Specifications

General

Processor	Intel Pentium II
Graphics	Neomagic MagicGraph128XD
Operating System	Windows 95, Windows 98, or Windows NT 4.0
Resolution	800 x 600
Battery	Lithium-Ion
Optical Drive	Optional external CD-ROM drive
Ports	Serial, Parallel, VGA
Network	10/100 Ethernet
Clock Speed	233 MHz to 300 MHz
Display	12.1-inch TFT