Appendix B. Using PS2 Commands
You can enter the following PS2 command options from the DOS and
OS/2 command prompts to set the features for your computer.
When entering a command, enter it in the following syntax:
PS2 [
Parameter1
][
Parameter2
][
Parameter3
]
Syntax Rules
Refer to these notes when you enter a command.
Syntax Rule
| Select one of the options on either side of the vertical
bar ( | ).
Highlighted Enter the exact highlighted letters in either uppercase
or lowercase.
UPPERCASE Enter any value within the specified range for the
following:
XX: 0–20 HH: 0–23
MM: 0–59 SS: 0–59
The MM (minutes) and SS (seconds) parameters are
optional. The default values are 0.
lowercase Command elements in lowercase are optional. For
example, entering PS2 SE OF and PS2 SErial OFf gives
the same results.
Please note that the PS2 commands are subject to change without notice. If
you enter a command written in this section and receive an error, type PS2 ?
and refer to the online help menu.
Copyright IBM Corp. 1998 197
To Next Page
Loading...
Need help?
General
