IBM ThinkPad 600 - Installing the PC Card Support Software for OS;2

4 Type SETUP X (X=boot drive) and press Enter.
5 Select Primary Display on the display driver install panel and
click on OK.
6 Select NeoMagic MagicGraph 128/V/ZV/XD on the primary
display driver list panel and click on OK.
7 Make sure the source directory is A:\ and click on Install.
Follow the instructions on the screen.
8 After the installation is complete, remove the diskette, shut
down OS/2, and restart the computer.
Installing the PC Card Support Software for OS/2
To use the PC Cards, you need to install the following device drivers
and software associated with PC Card when installing an operating
system:
PC Card support program (PC Card Director):
– Card Services device driver
– Socket Services device driver
– PC Card Power Management device driver
– PC Card Director utility
PC Card client device drivers (only when PC Card Director does
not support the PC Card)
To install the PC Card support software for OS/2:
1 Start OS/2; then open the OS/2 full-screen command prompt.
2 Insert the PC Card Director for OS/2 Diskette into the diskette
drive; then type A:\PCMINST2 and press Enter.
Follow the instructions on the screen.
3 Click on OK when you have completed the installation.
4 Close all applications, remove the diskette from the diskette
drive, and restart the computer.
172
IBM ThinkPad 600 Online Book