Follow the instructions on the screen.
Installing the Display Driver for Windows NT
Install the video features to display various resolution and color depth
configurations.
To install the video features for Windows NT:
1
Start Windows NT, and log on with the user ID authorized as
an administrator.
2
Double-click on My Computer, Control Panel, and Display.
3
In the “Display Properties” window, click on the Settings tab;
then click on Display Type....
4
In the “Display Type” window, click on Change.
5
Click on Have Disk....
6
Insert the Video Features Diskette III for Windows NT into the
diskette drive; then click on OK.
A selection list appears listing the display device.
7
From the display devices in the selection list, select NeoMagic
MagicGraph 128ZV+/XD and click on OK.
The message “You are about to install a third-party driver”
appears on the screen.
8
Click on Yes; then follow the instructions on the screen.
9
Restart Windows NT to make the change effective.
After you restart Windows NT, the display resolution is set to
640x480 with 256 colors as a default. If necessary, change the
resolution and refresh rate as follows:
10
Double-click on My Computer, Control Panel, and Display.
11
In the “Display Properties” window, click on the Settings tab.
12
Click on List All Modes..., and select the resolution, color
depth, and refresh frequency, and click on OK.
Chapter 8. Installing Software 153
To Next Page
Loading...
Need help?
General
