type power at the command prompt and press Enter. If a screen
similar to the following appears, APM is successfully installed.
Power Management Status
-----------------------
Setting = ADV: REG
CPU: idle 32% of time.
AC Line Status : OFFLINE
Battery status : High
If not, add the following line to your CONFIG.SYS file, using a text
editor such as the DOS Editor:
DEVICE=C:\DOS\POWER.EXE
If you are using Windows 3.11
, follow these instructions to check and
install APM for Windows:
1
Start the computer.
Make sure that the current directory is Windows (usually
C:\WINDOWS>).
2
Type SETUP at the command prompt and press Enter.
The following appears:
Windows Setup
===============
If your computer or network appears on the Hardware Compatibility List
with an asterisk next to it, press F1 before continuing.
System Information
Computer: MS-DOS System
Display: MagicGraph128XD 8 ×6 256 small font
Mouse: Microsoft, or IBM PS/2
If MS-DOS System with APM appears for the item Computer:,
APM is already installed. Press F3 to exit the setup.
3
Using the Arrow keys (↑ , ↓ ), position the highlighted cursor
over MS-DOS System and press Enter.
4
Position the highlighted cursor over MS-DOS System with
APM and press Enter.
34
IBM ThinkPad 600 Online Book
To Next Page
Loading...
Need help?
General
