Troubleshooting guide
A television problem
Problem Cause and action
The screen is blank. Make sure that:
You enabled the television settings. You need to enable the settings every
time you start your computer to use the TV.
You enabled the video-out connector (TV-out) by doing the following:
1. Click on Start.
2. Move the cursor to Settings and Control Panel; then click on Control
Panel.
3. Double-click on Display.
4. Select the Settings tab.
5. Click Advanced....
6. Select the NeoMagic tab.
7. Make sure that the TV check box is selected.
8. Click Advanced Settings.
9. Select the TV Options tab.
If you need to set the TV Output Standards and Output Selection in
the procedure, make sure that you select the appropriate radio button
under TV Output Standards, and the Composite radio button under
Output Selections.
Chapter 4. Solving computer problems 151