Table 35. Main error events (continued)
Event Code Message Text and
Description
Details and Solution
2087 Error accessing the backplane
flash memory.
• Restart the library and if the error persists, replace the
chassis.
• Before the chassis is replaced, ensure that you remove all of
your tape cartridges.
• If magazines need to be removed to get access to the tape
cartridges, rst power down the device and then manually
release each magazine. Only one magazine must be opened
at a time.
2089 Incompatible Robotics
Assembly Detected
An incompatible robotics assembly is detected. The robotics
assembly was not powered on to avoid damage to the library.
Power off the library and replace the robotics assembly with a
compatible version.
2092 Locking the accessor
assembly failed during Power
Down process
Power up the library. In case of accessor failure, error events
are reported at power-up. Look for the proposed solution for
these new errors. If no new errors are reported, the 2092
event can be ignored.
2093 Communication to accessor
controller couldn’t be
established.
Restart the library and if the error persists, replace the
accessor assembly.
2094 An emergency stop condition
was detected in one or more
modules and prevented the
accessor from running the
inventory scan.
• Ensure that all magazines, top or bottom covers and unit
locks are inserted and properly locked.
• Insert all open magazines and install all necessary covers
and unit locks before powering on the library.
• Ensure that all modules are powered and have the
interconnect cable properly attached.
2095 Inventory scan failed because
of accessor positioning
problem.
Check for obstructions in the horizontal pathway of the
accessor such as a cartridge that is sticking out or lying on the
accessor table.
2096 Initializing a communication
interface on the library
controller failed.
Restart the library, and if the error persists, replace the library
controller.
2097 Accessor reinitialization failed. Restart the library and if the error persists, replace the
accessor assembly.
2100 Robotic move to requested
position failed.
• Check for obstructions in the pathway of the accessor such
as a cartridge that is sticking out.
• Verify module alignment and frame alignment.
• Check if the accessor is stuck in the lock mechanism. Move
the accessor away from the lock mechanism and enable the
lock mechanism correctly.
2103 Incorrect stack assembly, too
many expansion modules
below main library.
Ensure that no more than three expansion modules are
mounted and connected below or above main library.
94 IBM TS4300 Tape Library Machine Type 3555: User's Guide
To Next Page
Loading...
Need help?
General
