Rev 2015-03-02 17
GV10x OPERATION AND SAFETY MANUAL
4.1.3. Setting Parameters with Remote Control Software
4.1.3.1. Establish physical connection between PC and GV10x (BT or 2U) Controller:
To communicate with the GV10x remotely, connect a 9-pin Serial connector from the
Controller back panel to a PC using the proper cable. A standard USB serial converter
cable can be used with laptops that do not have exposed serial ports. See Appendix D:
GV10x Remote Control Test Report for more information.
4.1.3.2. Run software that has been written to remotely communicate with and control the
GV10x:
Command documentation is shown in Appendix C: GV10x Remote Control
Specifications. Remote communications can quickly be confirmed and demonstrated
using Windows Hyper Terminal, generally found under Start->All Programs -
>Accessories (not available in Windows Vista.)
ibss Group provides Remote Control Software as shown in Figure 4-5a. Contact ibss
Group for information on other user-written or third-party control software.
For information on how to install and use GV10x-RC15, please see ReadMe.pdf that is provided
on the GV10x-RC15 installation CD or ZIP file.
Figure 4-5a. GV10x Remote Control Software
To Next Page
Loading...
Need help?
General