Icom GM600 - BASIC OPERATION (Continued); Setting the Call Channel

14
5
BASIC OPERATION
You can set the Call channel with your
most often-used channel for quick recall.
q Push [MENU] to display the Menu
screen.
w Rotate [CH/ENT] to select “Settings,”
then push [ENT].
+
Push
Rotate
e Rotate [CH/ENT] to select “Radio,”
then push [ENT].
+
Push
Rotate
r Rotate [CH/ENT] to select
“Call Channel,” then push [ENT].
+
Push
Rotate
t Rotate [CH/ENT] to s elect the
desired channel to be set as the Call
channel, then push [ENT].
+
Push
Rotate
• Goes back to the previous screen, after
pushing [ENT].
y Push [MENU] to return to the Main
screen.
■ Setting the Call channel
TIP: To conrm that your setting is
correctly set, hold down [16/C] for 1
second. (p. 13)
TIP: After receiving a signal, or you
operate the transceiver, the transceiver
enters the Radio Telephone (RT) mode.
In the RT mode, you can make voice
communications except for the DSC
operation.
• “ ” is displayed while in the RT mode.
• “ ” is displayed when the RT mode
task is on hold.
• “ ” or “ ” disappears (Returns
to the Standby mode) if no operation
occurs during the preset period of time.
(p. 82)
■ Selecting a channel (Continued)