Icom ic-2730A User Manual

36
5
SCAN OPERATION
New2001
5
SCAN OPERATION
■ About the scan function
D VFO scan (p. 41)
•ALL (Full scan)
Repeatedly scans the entire band.
118 MHz 550 MHz
Scan
P SKIP
P SKIP
Jump
•BAND (Selected band scan)
Scans all frequencies over the entire selected band.
Band edge Band edge
Scan
P SKIP
P SKIP
Jump
•PROG 0~24 (Program scan)
Scans the program scan edge range.
Band
edge
Lower
freq.
Higher
freq.
Band
edge
Scan edges
ScanJump
Jump
•P-LINK0~9 (Program link scan)
Sequentially scans the program scan edge ranges which
are set to link in the “P-LINK” (Program Link) item of the
EXMENU mode. (p. 14)
For your reference: The frequencies that are set as
“PSKIP” are not scanned. (p. 13)
NOTE: At least one program scan edge range must be
programmed to start a program scan. (p. 38)
D Memory scan (p. 43)
•ALL (Full memory scan)
Scans all Memory channels.
•BAND (Selected band memory scan)
Scans all Memory channels in the same frequency band as
the selected channel.
•MODE (Mode memory scan)
Scans Memory channels that are programmed with the
same receiving mode as the currently selected mode.
D Memory bank scan (p. 43)
•ALL (Full bank scan)
Scans all banks.
•B-LINK (Bank link scan)
Sequentially scans the banks that are set to link in the
“B-LINK” (Bank Link) item of the EXMENU mode.
•BANK-A~J (Bank scan)
Scans the Memory channels in the selected bank.
For your reference: The frequencies that are set as
“PSKIP” or “SKIP” are not scanned. (p. 44)
NOTE: Two or more memory channels must be pro-
grammed to start a Memory scan.

Icom ic-2730A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Mode	FM
Power Output	50W, 15W, 5W
Antenna Connector	SO-239
Power Supply Requirement	13.8V DC ±15%
Voltage	13.8V DC
Operating Temperature	-10°C to +60°C
Number of Channels	1000
Current Consumption	13A (at 50W output)