38
5
SCAN OPERATION
New2001
5
SCAN OPERATION
D Receive mode during a scan
•Theselectedmodeisusedbythescan.
•Duringamemoryorbankscan,thechannel’smodeisused
by the scan.
Blinks
Scanning in the FM mode
Displays the scan type
Blinks
D When a signal is received
When a signal is received, the scan pauses for approximately
10 seconds (default), and then resumes.
The scan resumes approximately 2 seconds (default) after
the signal disappears.
To manually resume the scan, rotate [DIAL]S.
•Thesesettingscanbechangedinthe“PAUSE”(PauseTim-
er) item or “RESUME” (Resume Timer) item of the MENU
mode. (pp. 12, 21)
D Scan name
A desired name can be entered to each Program scan edge.
(p. 39)
When the scan name is entered, it is displayed on the scan
type setting screen.
■ Entering scan edges
Enter the higher and lower frequency edges as the scan edge
range for programmed scans.
Each program scan edge range has its own tuning step and
operating mode settings.
The default settings differ, depending on the transceiver’s ver-
sion.
You can enter a total of up to 25 program scan edge ranges.
The C, S, or D in the
instructions indicate the
area of the controller.
C: Center
S: Side
D: Display
Continued on the next page ☞
To Next Page
Loading...
Need help?
General
