Icom IC-7410 - Page 36

29
3
BASIC OPERATION
N Frequency setting (continued)
D"ANDEDGEWARNINGBEEP
You can hear a beep tone when you tune in or out of
an amateur band’s frequency range. A regular beep
sounds when you tune into a range, and an lower tone
error beep sounds when you tune out of a range.
Also, the TX icon appears if the selected frequency is
in or out of an amateur band, when an option other
than “OFF” is selected.
sh ” is displayed, instead of the regular TX icon “ ,”
while the operating frequency is out of an amateur band.
q Hold down [MENU] for 1 second to enter the Set
mode.
w Push [Y](F-1) or [Z](F-2) to select “Band Edge
Beep.”
e Rotate [DIAL] to select the desired band edge warn-
ing beep setting.
 s/&& "ANDEDGEBEEPIS/&&
 s/.$EFAULT 7HEN YOU TUNE INTO OR OUT OF
the default amateur band’s fre-
quency range, a beep sounds.
(default)
 s/.5SER 7HEN YOU TUNE INTO OR OUT OF
a user programmed amateur
band’s frequency range, a beep
sounds.
 s/.5SER487HEN YOU TUNE INTO OR OUT OF
a user programmed amateur
band’s frequency range, a beep
sounds. Also transmission is in-
hibited outside the programmed
range.
s(OLDDOWN;F-3] for 1 second to reset to the default set-
ting, if desired.
r Push [MENU] to save, and exit the Set mode.
The beep output level can be set in the “Beep Level”
item of the Set mode. (p. 85)
!BOUTTHEUSERBANDEDGEFREQUENCIES
7HENh/.5SERvORh/.5SER48vISSELECTEDIN
the “Band Edge Beep” item, a total of 30 band edge
frequencies can be programmed in the “User Band
Edge” item. See the next page for details.
If “OFF” or “ON (Default)” is selected, the “User Band
Edge” item does not appear in the Set mode.
[][]
[DIAL][MENU]
ON (Default)
Ù 6 Ú ON(Default)
SET Band Edge Beep
ON (User) selection
Ù 6 Ú ON(User)
SET Band Edge Beep
[User Band Edge] item
Ù 7 Ú DEF EDT
SET User Band Edge