Icom IC-7410 - Page 37

30
3
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
D0ROGRAMMINGTHEUSERBANDEDGE
7HENh/.5SERvORh/.5SER48vISSELECTEDIN
the “Band Edge Beep” item, the “User Band Edge”
item appears in the Set mode.
A total of 30 band edge frequencies can be pro-
grammed in the “User Band Edge” item.
./4%
s!LLFREQUENCYRANGESARE SETTODEFAULTSO YOU
should delete or change them to add the desired
band edge frequency.
s0ROGRAMEACHCHANNELFROMLEFTTORIGHTANDEACH
frequency must be higher than the preceding fre-
quency.
s4HEFREQUENCYTHATISDUPLICATEDOROUTOFANAMA-
teur band, cannot be programmed.
q Hold down [MENU] for 1 second to enter the Set
mode.
w Push [Y](F-1) or [Z](F-2) to select “Band Edge
Beep.”
e Rotate [DIAL] to select either “ON (User)” or “ON
5SER48v
r Push [Z](F-2) to select “User Band Edge.”
t Push [EDT](F-4) to display the “EDG” screen (Band
Edge Program).
y Push [Y](F-1) or [Z](F-2) to select the desired band
edge.
s(OLDINGDOWN;Y](F-1) or [Z](F-2) continuously selects
the band edges.
s0USH;Ω ≈](F-3) to select the upper or lower band edge
frequency entry status.
s(OLDDOWN;$%,=&FORSECONDTODELETETHESE-
lected band edge.
s0USH;).3=&TOINSERTANEWBLANKBANDEDGE
u Input the desired frequency with the keypad, then
push [F-INP ENT].
s0USH;'%.%s=to input decimal point (“.”) between the
MHz and kHz digits.
i Push [MENU] to save.
o Push [MENU] again to exit the Set mode.
4ORESETTHEBANDEDGEFREQUENCIES
If you want to reset the band edge frequencies to their
default (initial) settings, select the “User Band Edge”
item, then hold down [DEF](F-3) for 1 second.
The band edge initialize screen appears, then hold
down [YES](F-4) for 1 second to reset all band edge
frequency settings to their default settings.
ON (User) setting in the
“Band Edge Beep” item
Ù 6 Ú ON(User)
SET Band Edge Beep
“User Band Edge” item
Ù 7 Ú DEF EDT
SET User Band Edge
“EDG” screen
 1   INS DEL
EDG
1.600.000- 29.999.999
“User Band Edge” item
Ù 7 Ú DEF EDT
SET User Band Edge
Band edge initialize screen
NOYES
SET Initialize Edges?
Ù 7 Ú DEF EDT
SET User Band Edge
Hold down
Hold down
[][][]
[] [DEL]
[DIAL][MENU]
Keypad