41
7
DV MODE OPERATION (Optional UT-121 is required for IC-91A)
7
■ Digital repeater operation
Repeater call sign must be programmed for repeater opera-
tion in both digital voice and slow-speed data communica-
tions.
DD
Repeater call sign programming
q Select B band as the main band. (p. 00)
w Enter “R1” or “R2” in call sign set mode. (p. 00)
• RPT1 or RPT2 CALL SIGN screen is displayed.
e Rotate [DIAL]
†
to select the desired call sign memory,
“R01” to “R60.”
r Push [6/M.N](
≈≈
) to enter call sign programming mode.
• The 1st digit blinks.
t Rotate [DIAL]
†
to select the desired character or code.
• Push [3/LOW](A/a) to change the character group from “AB” (al-
phabetical characters; capital letters), “12” (numbers) and “/”
(symbols) in sequence.
• Set “/” at the 1st digit then set the desired area repeater’s call
sign (in different zone) for CQ call (“/” stands for “CQCQCQ”) in a
different zone operation. (p. 00)
y Push [6/M.N](
≈≈
) to select 2nd digit, then rotate [DIAL]
†
to
select the desired character or code.
• Push [6/M.N](
≈≈
) to move the cursor right; push [4/DUP](
ΩΩ
) to
move the cursor left.
• 2nd digit blinks (1st digit stops blinking).
u Repeat the steps t and y to enter the desired repeater
call sign.
• Up to an 8-digit of call sign can be set.
• Push [7/DSQ/TONE] when setting with the gateway connection
if the set repeater has gateway capability.
• If un-necessary character is entered, push [6/M.N](
≈≈
) or
[4/DUP](
ΩΩ
) to select the character, then push [1/SCOPE](CLR)
to erase the selected character, or push and hold
[1/SCOPE](CLR) for 1 sec. to erase following all characters from
the cursor.
i Push [5/SKIP](ï) to store the programmed call sign with
note and returns to RPT1 or RPT2 CALL SIGN screen.
o Push [MENU/LOCK] to return to frequency indication.
To Next Page
Loading...
