28
5 BASIC OPERATION
■ TV channel operation
TV channel operation is available only when TV channels are
programmed using the optional RS-91.
(p. 125) Also available
for A band operation only.
D TV channel receiving
q Push [CALL/RX➝CS] several times to select TV chan-
nels.
•“TV” and channel number appear.
w Rotate [DIAL] to select the desired channel.
• While pushing and holding [BAND], rotating [DIAL] selects the
all channels including skip channel.
D Skip channel setting
Unwanted channels can be skipped for rapid selection, etc.
q Push [CALL/RX➝CS] several times to select TV chan-
nels.
•“TV” and channel number appear.
w Rotate [DIAL] to select the channel to be skipped.
• To clear the skip setting, rotate [DIAL] while pushing and holding
[BAND] to select a skip channel.
e Push and hold [5/SKIP] for 1 sec. to toggle the skip set-
ting ON and OFF.
•“SKIP” appears when the channel is set as skip channel.
D Automatic TV channel programming
TV channels can be programmed automatically.
q Push [CALL/RX➝CS] sev-
eral times to select TV chan-
nels.
•“TV” and channel number ap-
pear.
w Push [2/SCAN] to start TV
channel programming.
• The programming will automatically stop when scanning all
channels.
To Next Page
Loading...
