Icom IC-91AD - I Memory Bank Scan

78
9 SCAN OPERATION
■ Memory bank scan
IMPORTANT!: To perform memory bank scan, 2 or more
bank channels MUST be programmed, otherwise the scan
will not start.
qPush [MR/S.MW] several times to select memory bank
mode.
wSet the squelch level.
eWhile pushing and holding [2/SCAN], rotate [DIAL] to se-
lect the desired scanning type.
•“ALL” for all bank scan; “BANK-LINK” for bank link scan or
“BANK-x” for bank scan (x= A to Z; programmed bank groups
are only displayed.), “DUP” for duplex scan.
rRelease [2/SCAN] to start the selected scan.
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction, or resumes
manually.
tTo stop the scan, push [VFO/MHz].
The bank-link setting can be changed in scan set mode.
See page 00 for details.
Duplex scan function: Repeatedly scans two frequencies
(transmission/reception) during duplex scan operation.
FM
A
µ
888
148800
• During all bank/bank link scan • During bank scan
FM
A
µ
A88
148800
FMFM
A
146 010
µ
A01A01
SCAN:ALL
FM
A
148 800
µ
A01A01
SCAN:BANK-LINK
FM
A
148 800
µ
A01A01
SCAN:BANK-A
P SKIPSKIP
P SKIPSKIP
P SKIPSKIP
¥ All bank scan selection
¥ Bank scan selection
¥ Bank link scan selection
Selectable between A to Z
if programmed
[DIAL]